Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Lynwood?
Most gate repairs in Lynwood run between $150 and $650, with the typical repair landing around $300 for a worn motor or control board on a residential swing gate. Simple fixes like a misaligned latch or a damaged sensor sit at the low end, while commercial slide operators and full motor replacements push past $900. Below is a line-by-line look at what drives those numbers, so you can plan for the bill before a technician knocks on the gate.
Gate Repair Cost Breakdown (2026)
Here’s how gate work prices out across Lynwood in 2026. These are typical ranges for the market. The written estimate sets the final price after we’ve actually looked at your system.
| Repair Type | Typical Cost Range | Notes |
|---|---|---|
| On-site diagnostic | $0 – $95 | Often waived with the repair estimate |
| Latch, hinge, or track adjustment | $120 – $250 | Manual gates, quick fixes |
| Sensor alignment or replacement | $150 – $320 | Safety sensors, photo-eyes, loop detectors |
| Control board replacement | $280 – $650 | Depends on brand: Mighty Mule vs. FAAC or DoorKing |
| Gate motor repair | $350 – $750 | Bearing, gear, or winding service |
| Full motor replacement | $550 – $1,200 | Swing operators and slide operators differ |
| Remotes and receiver reprogramming | $80 – $200 | Adding or replacing access remotes |
| Low-voltage wiring repair | $180 – $500 | Length of run affects the price |
| Barrier arm service | $250 – $700 | Commercial parking and access control |
| Full electric gate system replacement | $2,500 – $6,500 | Operator, controls, and safety devices |
The top of each range shows up when the part is a professional-grade operator on a commercial entrance, or when a technician has to trace a fault through several feet of buried wire. The bottom of each range is the simple stuff: a single sensor, a fresh battery in the receiver, a gate that’s just out of square. Residential systems like Ghost Controls or Linear usually price at the low end. Commercial systems like BFT, DoorKing, and FAAC price higher because the parts are heavier and the diagnostic work is deeper.
What the Diagnostic Covers
When we arrive, the first step is a full look at the gate and operator. We test the motor, run the cycle, check sensors, inspect hinges and wheels, and read any fault codes the control board logs. The diagnostic tells us whether this is a $150 sensor swap or a $900 operator replacement. If we can fix it on the spot, great. If not, you get a written estimate before we touch a wrench.
What Affects Gate Repair Pricing in Lynwood
No two gate repairs look alike, even on the same street. Here’s what moves the number up or down on this side of Los Angeles County:
- Brand and model. A residential Mighty Mule or Ghost Controls operator uses standard parts that are easy to source. A DoorKing or FAAC commercial system uses heavier-duty components that cost more to replace, and the diagnostic work is more involved. We work on all nine brands, so we know which is which before we arrive.
- Swing vs. slide vs. barrier arm. Swing gates are the simplest to service. Slide gates have more moving parts, and a track that’s out of level costs more labor to correct. Barrier arms on commercial lots add access control wiring to the job.
- Manual vs. electric. A manual gate that won’t latch is a $120 – $250 fix. An electric gate that won’t open could be a sensor, a control board, a motor, or the wiring feeding it. Electric systems are where most of the diagnostic time goes.
- Wiring condition and length. Lynwood lots range from tight residential driveways to wide commercial entrances. The longer the low-voltage run from the control box to the operator, the more time it takes to trace a fault or replace a wire.
- Age of the system. Older operators hit a point where parts get scarce and the price climbs. We’ll tell you honestly when repair still makes sense and when replacement is the better move.
- Property type. A single-family home gate is one job. An HOA entrance or a commercial lot with multiple gates and access control is a bigger scope, and the pricing reflects the added time and coordination.
One more thing that doesn’t drive the price but matters for how the job goes: Lynwood winters are mild and dry, so rusted hinges and frozen operators aren’t a local problem the way they are in colder parts of the country. What we do see more of is dust and grit working into tracks and gears, and sun exposure aging out plastic sensors. Those are cleaning and replacement jobs, not weather emergencies.
Gate Repair vs. Gate Installation: Which Costs Less?
Repair almost always costs less in the short term. A $300 motor fix on a workable system beats a $3,500 replacement every time. But there’s a line where repair stops making sense, and we’ll tell you plainly when you reach it.
When Repair Makes Sense
If the operator is under about 10 years old, the parts are still available, and the fault is isolated – a sensor, a board, a belt – repair is the right call. Most of what we see on residential swing gates falls into this bucket.
When Replacement Is the Better Move
If the motor has been repaired twice in as many years, if the control board is obsolete and the brand no longer sells the part, or if the whole system is mismatched to the gate it’s driving, replacement saves money over time. A new operator with proper safety devices also brings the gate up to current standards, which matters for HOAs and commercial properties.
How to Save on Gate Repair
A few practical moves keep the bill down without cutting corners:
- Get the written estimate before work starts. A free, no-obligation estimate tells you the real number up front. Call (855) 360-4375 and we’ll set it up.
- Fix small things before they get big. A sensor that’s dirty or misaligned is a $150 – $320 job. Left alone, it can mask a motor fault that costs five times as much to fix.
- Know your brand. When you can tell us the brand and rough age of your operator – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, or Mighty Mule – we arrive with the right parts and the right diagnostic habits. That saves labor time on the visit.
- Keep the gate track clear. Sweeping grit and leaves out of the track and the operator housing cuts down on wear and the repairs that follow from it.
- Ask for a repair quote and a replacement quote together. When the operator is borderline, having both numbers in hand makes the decision easy.
For a closer look at how our gate repair service works, including what a scheduled visit covers, that page walks through the process step by step.
Electric Gate Repair Pricing in Lynwood
Electric gate repair is where most of our calls originate, and it’s the area where a real range beats a guess. The most common electric failures we see in Lynwood, with typical 2026 pricing:
- Safety sensor replacement: $150 – $320. Photo-eyes and loop detectors fail from dust, sun, and age.
- Control board repair or replacement: $280 – $650. This is the brain of the operator, and a fault here can present as a dozen different symptoms.
- Motor or gearbox service: $350 – $750. Bearings, gears, and windings all wear at different rates.
- Full operator replacement: $550 – $1,200. Residential and light commercial systems sit at the low end; heavy-duty operators at the high end.
- Wiring diagnostics: $180 – $500. Tracing a fault from the control box to the operator takes time, and time is the cost.
Because we work exclusively on gates, our diagnostic process starts with your brand. If you have a FAAC swing operator at a commercial entrance or a Mighty Mule on a residential driveway, we’ve seen both, and we know the common failure points for each. That familiarity is what keeps the bill from creeping up through trial-and-error.
When to Call a Technician Instead of DIY
Some gate issues are a quick fix. Others carry genuine risk. The operator wiring on an electric gate carries line voltage, and a heavy slide or swing panel under power can cause serious injury if it moves when it shouldn’t. We recommend a trained technician for anything involving the motor, the control board, the power feed, or a gate that moves on its own. A gate that’s heavy enough to stop a vehicle is not a weekend project.
For simple things – a manual latch that’s out of alignment, a remote that needs a new battery – a homeowner can usually handle it. For anything electrical or anything involving a gate that has become unpredictable, call a technician. That’s what we do. To see the full scope of what a Gate Repair Lynwood visit covers, our main page lays it out.
What Happens When You Call
Call (855) 360-4375 and we’ll ask about your gate: brand, type (swing, slide, or barrier arm), and what it’s doing or not doing. We book the visit, arrive with the tools and parts knowledge for your system, and give you a written estimate before any work begins. Same-day service is often available. Fast dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. We answer 24/7, so a call that comes in overnight gets booked into the next opening.
A few things that make the visit go smoothly:
- Have the brand name handy if you know it. LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule all show up on Lynwood properties, and knowing which one you have speeds things up.
- Note what the gate is doing. Does it open halfway and stop? Reverse for no reason? Click but not move? Those symptoms point to different faults.
- Check whether the issue is the operator or the gate itself. A sagging gate can bind an otherwise healthy motor.
FAQs – Gate Repair Cost
How much does gate repair cost in Lynwood in 2026?
Most gate repairs in Lynwood cost between $150 and $650, with a typical repair around $300. Sensor and latch fixes sit at the low end; motor replacements and commercial control board jobs sit at the high end. The written estimate sets the final price. Call (855) 360-4375 for a free quote.
Is it cheaper to repair or replace an electric gate operator?
Repair is usually cheaper – a $300 motor fix beats a $3,500 replacement. Replacement becomes the better move when the operator is obsolete, has been repaired repeatedly, or no longer matches the gate it drives. We’ll quote both so you can compare. Call (855) 360-4375 for a free estimate.
How much does a new gate motor cost in Lynwood?
A full motor replacement typically runs $550 to $1,200, depending on whether it’s a residential operator or a heavy-duty commercial one. Residential brands like Mighty Mule and Ghost Controls price at the low end; BFT and DoorKing commercial systems at the high end. Call (855) 360-4375 for an exact number on your brand.
Can you repair my gate the same day?
Often, yes. Many sensor, remote, and latch repairs are done on the first visit, and simple motor fixes usually are too. Parts-dependent jobs may need a second visit. Fast dispatch runs from 7am to 7pm, Sunday through Friday. Call (855) 360-4375 and we’ll find the earliest opening.
What brands do you repair in Lynwood?
We service nine brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That covers residential swing gates through commercial slide and barrier-arm systems. If you’re not sure which brand you have, tell us the model or send a photo when you call (855) 360-4375.
Do you charge for the estimate?
The estimate is free. We look at the gate, diagnose the fault, and give you a written price before any work starts. No diagnostic fee, no trip charge. Call (855) 360-4375 to set one up.
Get a Free Gate Repair Estimate in Lynwood
Whether your gate is a stubborn residential swing operator or a commercial slide system that’s down, the first step is the same: a free, written estimate that tells you exactly what the repair will cost. We work on all nine major brands, we do gate work exclusively, and we’ll give you the honest number – repair if repair makes sense, replacement if it doesn’t. Call (855) 360-4375. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Lynwood market as of 2026. Gate Repair Lynwood offers free estimates – call (855) 360-4375.
What Our Customers Say
"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Maria Castillo"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
- Omar Hassan"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
- Alejandro Vargas